RC Heli Forums -=DO IT INVERTED=-

A few people have asked me in the past about my DX7 settings for the T-Rex 450.

I just set it up today (No settings accurate to the Gyro as Ido not have one right now) and wanted to post the settings that would be a good starting point.

Keep in mind servos and mechanical setup may change these settings. These would be a good starting point.

I have properly listed the equipment I am using in the Doc that is attached.


Please remember that proper mechanical setup is a must.

These settings give me -11 / +11 for pitch.

Also keep in mind I do not run any stock electronics.

I made some corrections to spelling and adjusted the Travel Adjust for the Gyro.

I still need to make some minor Adjustments to fully Dial in this machine but these settings are a great place to start.

If you are not that familiar with the T-Rex and need a lot more info please ask as there are many of us who can help.

You can also head over to www.HeliFreak.com and look for the Finless Bob Videos on the T-Rex 450, he goes through the entire setup of the machine and will help you get your machine set to fly right off the bench (If followed in close detail) keep in mind that you will likely still have to track the Main Blades unless you are using the higher end blades.